(1) Inspection and test before operation

After the centrifuge is installed, the pre-operation inspection, the idling test and the load test should be carried out in sequence, and the production operation can be carried out only after the corresponding requirements are met.

Before operation should check:

1. Whether the parts are installed correctly, and the fasteners must not be loose;

2. Sufficient grease should be added to each lubricating part;

3. There is no abnormality in the casing and the drum, and the drum should be turned by hand, and the rotation should be flexible and free of friction;

4. The braking device is flexible and reliable;

5. Instantly start the motor, and the drum rotates without any abnormality. Special attention should be paid to the rotation direction of the drum should be consistent with the direction indicated by the arrow on the sign, and it is strictly forbidden to run in the opposite direction.

The dry running test can further check whether there is abnormal vibration and noise, and whether the electrical installation is correct; the load running test can determine the operating parameters of production operation. http://www.tongjiangmac.com/